Published July 21, 2023, 9:35 p.m. by Liam Bradley
$2 for 2-Layer PCBs & $5 for 4-Layer PCBs: https://jlcpcb.com
More project information(Code,Schematic,etc):- https://nematicslab.com/diy-iot-weather-station-arduino-blynk/
To add esp8266 boards in arduino IDE software: https://nematicslab.com/install-esp8266-esp32-boards-on-arduino-ide/
For project-related questions use Facebook or Twitter @nematicslab
2) Midnight Prophet by Sarah, The Illstrumentalist
--------------------electronics Starter kit Tools--------------------
Soldering Iron - https://www.banggood.in/custlink/DKGKUAqCKa
Solder wire - https://www.banggood.in/custlink/mv3vks2ROf
Helping Hands - https://www.banggood.in/custlink/vmvmMAqd0C
Hot Glue - https://www.banggood.in/custlink/D3GDMAkWDS
----------------Little information about Video-------------------
This project is related to initial steps in iot world, here we will interface DHT11/DHT22 sensor with nodemcu or other esp8266 based board and receive data on internet we are going to use Blynk application, use the following tutorial link if you are not familiar with blynk application.
For Blynk (it require only few minutes): https://docs.blynk.cc
After this you are require to add esp8266 boards in your arduino IDE software, use following link
There are simple hardware connections, you are not going to deal with any messy connections, so recreate & enjoy this project.
You may also like to read about:
2CUTURL
Created in 2013, 2CUTURL has been on the forefront of entertainment and breaking news. Our editorial staff delivers high quality articles, video, documentary and live along with multi-platform content.
© 2CUTURL. All Rights Reserved.